Buhler 65 Series Spécifications télécharger pdf (Page 10)

Assembly / Start-up - 45 Series Rotary Tiller

Assembly Instructions

The machine is shipped with the PTO shaft not installed.

To install the PTO driveline on the machine, follow this procedure.

1. Clear the area of bystanders, especially small children.

2. Clean the splines on the yoke and the input shaft.

3. Align the splines on the yoke and the shaft.

4. Attach the driveline to the tiller by removing the tapered pin and sliding the yoke onto the

gearbox shaft. Line up the pin with the groove in the gearbox shaft and fasten with the tapered

pin. The plastic gearbox PTO guard has a removable door on top to access the pin. The A-frame

brace can be removed to improve accessibility. Replace the brace after tightening the nut on

the tapered pin.

5. Be sure the yoke is locked in position. Pull on the yoke to be sure the pin clicks into position.

6. Be sure that the PTO shaft is the appropriate length for the tractor/Tiller combination. Refer to

Driveline Dimension Section for details.

Start-up

Machine Break-in

Although there are no operational restrictions on the Tiller when used for the ﬁrst time, it is

recommended that the following mechanical items be checked:

• After operating for 1/2 hour or after completing 1/2 acre:

- Check all nuts, bolts and other fasteners. Tighten to their speciﬁed torque level.

- Check that the blades are in good condition and bolted securely to the rotor.

- Check the oil level in the gearbox. Add as required.

- Check that the PTO driveline shield turns freely.

- Lubricate all grease points.

• After operating for 5 hours and 10 hours:

- Repeat the items above.

- Then go to the regular service schedule as deﬁned in Section 5.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 41 42

Pas de commentaire

Buhler 65 Series Spécifications Page 10