Buhler 65 Series Spécifications télécharger pdf (Page 17)

9. Use the 3-point hitch to raise the machine.

10. Remove the blocks from under the Depth Gauge Shoes.

11. Reverse the above procedure when unhooking from the tractor.

Field Operation

Farm King 45 Series Rotary Tillers are designed with the inherent ﬂexibility of operating well in

almost any kind of soil and terrain conditions. However, the operator has the responsibility of

being familiar with all operating and safety procedures and following them.

Each operator should review this section of the manual at the start of the season and as often as

required to be familiar with the machine. When using, follow this procedure:

1. Review and follow the pre-operation checklist. Review Safety Instructions.

2. Attach the tractor to the machine.

3. Before going to the ﬁeld review Transporting Section, pull into the ﬁeld and position the

machine in a level area.

4. Lower into working position.

5. Set the machine.

- Level the frame: Use the screw jack on the right lift arm to level the frame from side to side.

- Depth: Use the Depth Gauge Shoes on each side to set the operating depth. Position the

Depth Gauge Shoes in the top hole for shallow tilling and in the bottom hole for deep

tilling.

ALERT

In soft soil conditions, the skid plates become less effective and

sink into the ground. Use the turnbuckle on the top link to set the

frame angle so the bottom of the Depth Gauge Shoes are level

when operating.

- Offset: The Category Pin Brackets can be moved 3" to 4" along the Deck Assembly to either

side of center if required. Center the machine for normal operation. Offset if the tire tracks

are wider than the machine or when tilling around trees, bushes or other areas.

- Drag Shield: Adjust the chain in the Adjustment Bracket to set the height of the Drag

Shield. Set the Drag Shield to just contact the tilled soil when operating.

Operation - 45 Series Rotary Tiller

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 41 42

Pas de commentaire

Buhler 65 Series Spécifications Page 17